Does anybody else think Hydrogen fuel cells would make a good alternitive fule?

February 21, 2009 by · 1 Comment
Filed under: Hydrogen Fuel Cell 

Eventually the Earth WILL run out of oil.
I thought this was the century of high tech,and high IQS'?
I guess that only refers to cell phones and Ipds or maybe plasma T.V.s

HHO Generator HVDC4

January 8, 2009 by · 25 Comments
Filed under: Water Fuel Cell 

Production test of new dry cell with 120VDC at 10 amps. Distiled water with a mix of K2CO3 and KOH without any additional capacitors hooked to the cell on the test with the video. Did one test right after the video with the 2200uf capacitors hooked to the cell and with the voltage on the cell at 120VDC I had a voltage going into the Bridge rectifier on 108VAC at 9.0 Amps and still made 12 seconds with 1 liter of HHO gas.

Alternative Energy: Take a look and signup! No cost to signup. Help the enviroment! http://www.gaswaterfuel.com

Pulsing Hydrogen Fuel Cell while Charging Battery (OU)

December 4, 2008 by · 25 Comments
Filed under: Water Fuel 

These concepts go back to Tesla, and his concepts of his Tesla Switch. Also, Bedini uses these Bi-Filer coils with much success. These are attempts to show overunity while using PWM (pulse width modulation).

Regards, sirHOAX

Pulsing Hydrogen Fuel Cell – Resonant Charging Choke Concept

November 25, 2008 by · 25 Comments
Filed under: Water Fuel 

Just trying to go over some concepts that Stanley Meyers had related to his patents regarding the Resonant Charging Choke. Which is basically Telsa’s BiFiler Coil Design.

Which basically is how to connect the WFC to the bifilar coil for maximum efficiency and if you have higher resistance and impedance than the WFC you can inhibit amp flow and allow voltage to go to the maximum.

Hydrogen Fuel Cell – Design Characteristics for Heavier Amps

October 27, 2008 by · 25 Comments
Filed under: Water Fuel 

Just going over a HHO-Cell design for coupling the anode and cathode of the electrodes in more rugged redundant means. With the connections on 1/4-20 3″ bolts. Using Lowes style wall plates for the HHO Cell, they appear to have a straighter surface than the stamped Home Depot style plates.

Regards, sirHOAX